My Mobile Mechanic 978's tie-rod swap raises an alignment question
The fast-starting tutorial counts turns to position the replacement, while viewers emphasize the wheel alignment afterward.
Why this story? The video opened at a pace of 115,911 views a day, 8.6 times a normal first day on this channel (13,512).
How to replace an outer tie rod 😎🔧#OuterTieRod #TieRodReplacement #MechanicTips #AutoRepair #Auto
Next story: A stuck sway bar nut brings a warning from My Mobile Mechanic 978
Sixteen turns off, sixteen turns on. My Mobile Mechanic 978 uses that count to position a replacement outer tie rod, and it's the detail viewers keep returning to: how close does counting get you?
The repair Short has drawn roughly 85,000 views in 13 hours, well beyond the channel's usual full-day audience for this format. Its comment section is already several times busier than a typical first day, with much of the discussion focused on getting the wheels aligned after the swap.
The mechanic starts by loosening the lock nut, warning against backing it off any farther. He removes the castle nut, then uses an air hammer against the steering knuckle to free the old joint. After counting rotations as he unscrews the worn part, he threads the replacement on by the same count, tightens the assembly and fits a new cotter pin.
Several commenters point out that replacement parts can differ in length, making the turn count a rough starting position rather than an alignment check. The clip ends with the hardware installed; it doesn't show a wheel alignment. That distinction is where this compact repair demonstration has prompted a longer conversation.
Published on Trari
A professional in this field? Want to write about Cars & motors on Trari? Tell us ›
Where next?
What viewers say
Still needs an alignment
@B86432See it on YouTubeYes counting the turns gets you "closd" but the new tierod will not be the exact same length as the old. So your 16 turns is very likely to position the ball head a few millimeters off.
@J123GSee it on YouTubeI never saw the zerk fitting installed.
@gordonhill7050See it on YouTube
Public comments from the video's page on YouTube
Want to know when somebody answers you?
- Channel
- My Mobile Mechanic 978
- Subscribers
- 161,000 ▲ 2,000 this week
- Channel views, last 7 days
- 4,604,227
- Channel views, pace per day
- 688,302 (on a normal day: 617,269)
- Video published
- November 14, 2026
- Video views so far
- 84,612 (less than a day online)
- Video views, pace per day
- 115,911
The numbers
The tie-rod tutorial has already passed the channel's usual first-day Shorts audience, with comments arriving unusually quickly too.
💡 Test your knowledge
Which tool does the mechanic use to free the tie-rod joint from the steering knuckle?
He uses an air hammer against the knuckle to pop the old tie-rod joint loose.


